ProClip iPod Touch 4th Generation Charging Holder With Tilt Swivel, Model 512191
Always keep your battery fully charged with this high quality custom made holder. It has a neat and discreet design, and keeps your device in an upright position for better reception. A cigarette lighter cable is permanently attached to this Holder creating a dock type connection for your device. When your device is slid into the holder it connects to the cable plug. The Holder angles 20 degrees for optimal viewing. Easily slide your device in/out of the holder. No more fumbling around for your device. Provides for safer driving when viewing, accessing and operating your device in your vehicle.
The Holder is custom made to fit your device with grooves on the inside walls to match the thickness of the device. This will allow your device to slide freely in/out of the holder. There is no need for you to disconnect any cable or press on any release buttons.
- Rapid and trickle charges device
- Charging cable permanently attached to holder
- Custom fit to your device
- Holds device securely
- Keeps your device within easy reach
- Easily slide device in and out
- Keeps your device upright for better cellular/GPS reception
- Neat and discreet design blends well with vehicle's interior
- Holder can tilt 20 degrees in any direction and swivel 360 degrees
- Made of heat and cold resistant ABS plastic
- The Tilt Swivel
The Tilt Swivel on the back of the Holder can tilt 15 degrees in any direction and swivel 360 degrees. The Tilt Swivel provides easy adjustment of your handhelds position for better viewing, and extends the Holder from the Mount by 20mm / 0.78in. You can also adjust the Holder to avoid unnecessary light reflection. (The Holder shown in the picture to the left is attached to a demo ProClip Mount).
The Tilt Swivel Base Plate on the back of the Tilt Swivel can be attached to any flat surface or mounting brackett. The base plate comes with 6 pre-drilled holes; 2 holes in a center line and 4 holes in an almost square like pattern to accommodate the AMPS hole pattern. Enclosed in the packaging are 4 self tapping screws and 4 machine screws with nuts. Dimensions of base plate: 50mm/1.96inches x 42mm/1.65inches. The 4 holes in the corners have a diameter of 4 mm, and the self tapping screw holes in the center have a diameter of 3 mm.
- Keep two devices on the same mount or use one at a time
If you have two devices you would like to have next to each other on your dashboard you may be able to have them on the same mount as shown in the General Picture to the left, by using our Horizontal Extension Plate.
You can also move a device/holder from car to car (mount to mount) or switch between to devices/holders on the same mount by using our Move Clip System. Please see the product category, Mounting Options, to the left to learn more about these options.
- Keep all your devices on the dasboard
If you have more than one device you would like to have on your dashboard, we may have the solution. Usually we have 2 or more mounts for each vehicle model so you can have all your devices securely attached on your dashboard. Many of todays customers order two or more mounts and holders - usually one for their mobile phone and one for their Handheld and/or Music Player like the General Picture below illustrates.
- Compatibility: iPod Touch 4th Generation
- Manufacturer Warranty (authorized online retailer): One Year Parts