Audison AF bit Plug and Play T-Harness for BMW RAM-Module Systems - AFBMW REAMP 3

Audison AFBMW REAMP 3 AF bit Plug and Play T-Harness for BMW RAM-Module Systems

The Audison AFBMW REAMP 3 Plug&Play T-Harness gives BMW audio-system installers and owners a vehicle-specific path for adding an Audison AF bit amplifier to vehicles equipped with RAM modules. It is designed for BMW "Hi-Fi" 676 sound systems and can also be used with BMW 688 systems, where it delivers seven of the nine channels required.¹

Rather than requiring a generic interface, the harness transfers all seven speaker-level outputs from the factory RAM module to the AF amplifier inputs. It also supplies speaker leads for the front and rear positions, underseat woofers and center channel. That combination lets the amplifier be configured around the supported factory speaker locations and the goals of the installation.

Built around the Audison AF bit platform and compatible BMW RAM architecture, AFBMW REAMP 3 brings signal routing and speaker connections together in one application-specific harness. It is intended for a properly matched 676 or 688 installation; other products may require modifications and additional connections to the vehicle. Active Sound "artificial exhaust note" defeat is handled separately through vehicle coding because this harness is not compatible with AP BMW ASD BYPASS.²

Key Features

Compatibility With RAM Module-Equipped 676 HiFi Audio Package

The 676 system uses 2 ohm woofers, so bridged amplifier operation requires a different woofer and wiring plan.³

Confirm Proper Application

Connector shape alone cannot identify the correct re-amplification harness; match the part to the vehicle and system before installation.⁴

Features

• Plug&Play AF Bit Integration
  Creates a vehicle-specific connection path between compatible BMW RAM audio systems and an Audison AF bit amplifier.
• Seven-Channel Signal Routing
  Carries the RAM module's seven speaker-level channels to the amplifier inputs.
• Multi-Location Speaker Leads
  Provides wiring for front, rear, underseat woofer and center speaker positions.
• Application-Specific Pinout
  Uses a dedicated pinout that must not be substituted with similar-connector ReAMP harnesses.
• Bridged-Channel Planning
  Requires attention to the 676 system's 2 ohm OEM woofers before channels are bridged.

Footnotes:

¹ BMW 688 systems require nine channels; AFBMW REAMP 3 delivers seven.

² AFBMW REAMP 3 is not compatible with AP BMW ASD BYPASS. Active Sound "artificial exhaust note" defeat requires vehicle coding.

³ BMW 676 HiFi systems use 2 ohm woofers. Do not bridge two channels into a 2 ohm load; protection shutdown or amplifier damage may result. For bridged operation, replace the OEM 2 ohm woofers with Audison APBMW S8-4.2 4 ohm woofers and confirm proper bridge wiring.

⁴ Audison APBMW ReAMP 1, APBMW ReAMP 2 and AFBMW REAMP 3 use identical connectors with different pinouts and are not interchangeable.